Batteries & Accessories for Cellular Phones
(732) 888-0615
Email information@pluscellular.com
Visit our Online Community Forum

Free Ground Shipping on All Orders No Minimum! Expires 10/31/05  ( Continental US Only)

We Accept:

Nokia 6100 Faceplate Installation Instructions

Important: These instructions are to guide you through the process and are to be used at your own risk. Do not poke at the circuit board! Do not have any other power source attached! A Torx T-6 screwdriver bit will fit those tiny screws on the back of the cell phone to permit removal of the circuit board...

	Ok. Start with a static free work surface. No carpet!
	Remove battery.
	Remove the four screws with the Torx T-6 screwdriver.
	Turn the cellular phone so that the face is down. This ensures that the earpiece will not fall out of position!
	Carefully separate the faceplate from the base.
	Remove outer cutout from the included lens foam padding.
	Carefully place cutout around the new faceplate window border.
	Install the earpiece speaker & rubber holder into the faceplate.
	Make sure the two metal contacts on the earpiece speaker are facing up!
	Fit the keypad and contact sheet onto the new faceplate.
	Carefully attach faceplate to the base.
	Reassemble with four T-6 Torx screws.
	Press the new lens onto the new faceplate.
	Keep your factory faceplate in case you need it for a warranty claim.
	Finished!

[ Home ] [ Up ]

Send mail to info@visionprods.com with questions or comments about this web site.
Copyright © 1999 PlusCellular
Last modified: September 13, 2001
AT&T Wireless, Audiovox, ClearVox, Ericsson, Kyocera, LGIC, Lucky Goldstar, Mitsubishi Motorola, NEC, Neopoint, Nextel, iDen, Nokia, Oki, Panasonic, Philips, Plantronics, Qualcomm, Samsung, Sanyo, Sprint, Sony, VAJA, CellSafe & Denso Touchpoint are all registered trademarks of their respective companies.